Nero Burning Death

I use the Samsung SD616 burner, is the speed of 16X, I have the speed to burn close to it (I used the super set of rabbit), but the air inside the disc burner to put a lock on, it is not entirely dead, the paper Can open the folder, procedures and documents are not open (to open in advance of the procedure can continue to run, such as travel), a disc out on all the good, the strength and vibrancy into this also.
, And so on and then I probably 4-5 minutes later, I opened the pop-up to be Nero, and then continue the steps will have to wait for 4-5 minutes, finally finished recording, and then did not direct, pop-up disk will not come, so there will be no burning Success, but still could be used in the dish …
in the end is where it has a problem??

Burning Plane load capacity of less than skinheads need to replace aging

the burning need to load more than the beam, the load can be difficult to write!

can try to uninstall the burning software, reinstall it to be resolved, then no need to be replaced

the first software of the principle of hardware you probably burn too fast for you every Burn times, NERO in the CD and DVD burning speed is set to 8X engraved plate, engraved with the load after you give it a try.
Usually as a result of burning too fast, and the disc may not be so high as to The speed to burn (a different brand of disk space, the quality, Kanpan other optical surface to write on the support of several X with a few X), when the use of NERO default or forced to burn high-speed, it will lead to disk read Poor access, the CD-ROM burner or are difficult to read.
Generally low-speed recording is the safest.