A display on the desktop into a black screen, to solve

17-inch PHILIPS CRT display

due to the typhoon, “Haig than the” rampant, salt water intrusion, quickly rescued the hosts put on the ground, but all the lines, cables were dirty after a bubble, including the display of the signal down to the ground Line.

There has been such a problem, the normal self-boot, the display is also normal, but as long as into the desktop, just to see the desktop of the moment, the display on a black screen.Display of lights from the Always into a flashing, do not feel like a sense of input signal.At the same time, or the normal operation of the host, can operate in the dark, including the shutdown.

Try to enter safe mode, the results of the same in safe mode desktop Just appear, and on display, continues to operate in the dark can be a normal shutdown.

Then think of it, all power lines, signal lines of the water bubble over, the water can be, the display signal line Under the screw, plug-D found in the corner there are traces of water, but also the end of the dirt more, this is where the problem lies? Yes signal or power problems?

.

Card out of your power is no problem with your signal line contact is not good to see you clean up the dust and see what the best
In the other computer to see if the display is not a question of loose equipment, systems re-look at the ah, as shown in front of it on display must be good, be able to look at the installed system hardware to software.