When the host is reflected in the boot, but it did not reflect the display, there is no “trickle” of the police …

I have a few days ago the same way, the normal now, I do not know why.'s BIOS should be set up options which do not Yes, in time to boot into the BIOS default settings look inside the restoration, or click on the Qing COMS jumper.Re-inserted inside the East under the host.May place the bad graphics wiped Goldfinger …humid weather…
clean-up chassis, power supply ~ ~ ~ dust is not the hard disk light Always? If you take a look at the reset button is not stuck? contact with the general problem is.If the machine does not report to the police or the test card Show 00 or FF, at the same time light and power the hard disk light has been lit, that is, between the CPU and motherboard.May be no contact, may be a bad CPU, the motherboard may be about 75% of the bad, are not allowed to say.There is And stores it on the test, not repair it.But in general the possibility of access to the most, be able to account for (my career maintenance).At the same time, look at the motherboard CPU has been around Na Yipai capacitor breakdown, Breakdown of the drum will come out, and some will flow “yellow water” (electrolyte).Capacitor problem and it will lead to the problem.'s Installed capacity will also be a friend to the next board down and main board at the base of the back of the CPU, with 95% The ethanol plug inserted, it may be because the dust problem.
Second, if the machine or boot ring has been stopped a long time, the display card or detection of C1, D1, E1, etc.(see BIOS chips), to consider memory Article.First off power to memory, do you clean, then rub on the skin remove Goldfinger oxide can also be used, such as wire or blade slot to scratch, and then planted at the direction to go.Note Must be at the direction of the anti-burn, but to the note! If you have or can not consider whether the damage to memory or whether the damage to the motherboard slot.
Again, if the machine stopped short boot-ming, or be able to detect card C1-off shows such as the A7 (see BIOS chips), consider the card.Method With the memory.If the card has been detected to be able to show the normal number of 26,32,65 and so on, that can have a normal start.Display at this time if there is no response, it is necessary to consider the damage to the card.
Finally, the display is Problem.This is very simple, take another test on a host of clear.